Frequently Asked Questions
(1)turbo charger install and operation
:Before the install:
Inspect the oil supply and drain lines for degradation and cracking. Clean or replace all oil lines.
NEVER put thread sealant on the turbo oil feed fitting. Using thread sealant will lead to turbocharger failure.
Installation guidelines:
Install the turbocharger, taking care to ensure that no dirt or foreign material enters the turbocharger openings. Always, use new gaskets and O-rings (where applicable). Do not connect the oil supply line or the air cleaner duct yet.
Pre-lube the turbocharger by pouring clean engine oil into the oil inlet hole of the turbo.
With your fingers, spin the compressor wheel several times to coat the turbocharger bearings with oil.
Pour more oil into the oil inlet hole to top it off. There may be some drainage, but this is of no concern.
Connect the oil supply line and the air cleaner duct.
Check for proper crankcase oil level.
With the fuel shut off to prevent engine start, crank the engine for 10-15 seconds, or until the gauge shows an oil pressure build up.
Start the engine and let it idle for 5-10 minutes. Do not rev the engine during this time.
Check the installation for any oil leaks.
Drive with low boost/light throttle to ensure proper break-in.
(2)Warranty
for 2 years from the date of purchase to the original purchaser of the vehicle in which the radiator was originally installed.
This warranty covers any parts furnished from the factory of EM, but does not include labor and materials of any kind not furnished by EM. This warranty does not apply to any equipment which shall have been repaired or altered outside the factory of EM in any way so as, in the judgement of EM, to affect its stability. This warranty does not apply to any equipment which has been subjected to misuse, negligence, or operating conditions in excess of those for which such equipment was designed. The warranty does not apply if the vehicle in which the cooling system was installed was used in commercial (including fleet), governmental, off highway or racing applications. This warranty does not cover the effects of physical or chemical properties of water or steam or other liquids or gases used in the equipment. This warranty is extended to and enforceable only by the first purchaser at retail.
EM warrants its products to be free from all defects in material and workmanship, as limited herein, shall be in lieu of and exclusive of all other warranties, expect warranties implied by law. All warranties, whether expressed or implied, including warranties of merchantability and fitness for purpose, which extended beyond the description herein, are expressly disclaimed.
In order to obtain EM, performance of any warranty obligation, purchaser must return the part or parts to the place of purchase, with all shipping or transportation charges prepaid. If, in the judgement of EM, this warranty does not apply to the part or parts returned to the place of purchase, then purchaser must prepay all return shipping or transportation charges from the place of purchase to purchaser, in addition to those shipping or transportation charges which purchaser shall have previously pre-paid.
Purchaser’s remedy for breach of this warranty is limited to repair or replacement of any part of parts for which the examination by EM shall disclose to have been defective. Purchaser’s remedy does not include reimbursement for any labor or material charges incurred by purchaser for removal or installation of parts, adjustments, repairs, or any other work done.
(3)how do I file a warranty claim ?
Please contact us or Dm us via live chat for your EM purchased product from to file a warranty claim.
EM will begin to process your claim. Preparing these beforehand may assist in expediting the warranty process.
1.Photo of Serial Number Sticker (9 Digit Code, Starts with a Letter)
2.Photos and Description of the Manufacturer’s Defect
3.Original Invoice/Receipt, That Adheres to our Buyer’s Policy
4.Full Name, Contact Information, Email Address, and Shipping Address
:Before the install:
Inspect the oil supply and drain lines for degradation and cracking. Clean or replace all oil lines.
NEVER put thread sealant on the turbo oil feed fitting. Using thread sealant will lead to turbocharger failure.
Installation guidelines:
Install the turbocharger, taking care to ensure that no dirt or foreign material enters the turbocharger openings. Always, use new gaskets and O-rings (where applicable). Do not connect the oil supply line or the air cleaner duct yet.
Pre-lube the turbocharger by pouring clean engine oil into the oil inlet hole of the turbo.
With your fingers, spin the compressor wheel several times to coat the turbocharger bearings with oil.
Pour more oil into the oil inlet hole to top it off. There may be some drainage, but this is of no concern.
Connect the oil supply line and the air cleaner duct.
Check for proper crankcase oil level.
With the fuel shut off to prevent engine start, crank the engine for 10-15 seconds, or until the gauge shows an oil pressure build up.
Start the engine and let it idle for 5-10 minutes. Do not rev the engine during this time.
Check the installation for any oil leaks.
Drive with low boost/light throttle to ensure proper break-in.
(2)Warranty
for 2 years from the date of purchase to the original purchaser of the vehicle in which the radiator was originally installed.
This warranty covers any parts furnished from the factory of EM, but does not include labor and materials of any kind not furnished by EM. This warranty does not apply to any equipment which shall have been repaired or altered outside the factory of EM in any way so as, in the judgement of EM, to affect its stability. This warranty does not apply to any equipment which has been subjected to misuse, negligence, or operating conditions in excess of those for which such equipment was designed. The warranty does not apply if the vehicle in which the cooling system was installed was used in commercial (including fleet), governmental, off highway or racing applications. This warranty does not cover the effects of physical or chemical properties of water or steam or other liquids or gases used in the equipment. This warranty is extended to and enforceable only by the first purchaser at retail.
EM warrants its products to be free from all defects in material and workmanship, as limited herein, shall be in lieu of and exclusive of all other warranties, expect warranties implied by law. All warranties, whether expressed or implied, including warranties of merchantability and fitness for purpose, which extended beyond the description herein, are expressly disclaimed.
In order to obtain EM, performance of any warranty obligation, purchaser must return the part or parts to the place of purchase, with all shipping or transportation charges prepaid. If, in the judgement of EM, this warranty does not apply to the part or parts returned to the place of purchase, then purchaser must prepay all return shipping or transportation charges from the place of purchase to purchaser, in addition to those shipping or transportation charges which purchaser shall have previously pre-paid.
Purchaser’s remedy for breach of this warranty is limited to repair or replacement of any part of parts for which the examination by EM shall disclose to have been defective. Purchaser’s remedy does not include reimbursement for any labor or material charges incurred by purchaser for removal or installation of parts, adjustments, repairs, or any other work done.
(3)how do I file a warranty claim ?
Please contact us or Dm us via live chat for your EM purchased product from to file a warranty claim.
EM will begin to process your claim. Preparing these beforehand may assist in expediting the warranty process.
1.Photo of Serial Number Sticker (9 Digit Code, Starts with a Letter)
2.Photos and Description of the Manufacturer’s Defect
3.Original Invoice/Receipt, That Adheres to our Buyer’s Policy
4.Full Name, Contact Information, Email Address, and Shipping Address